When Is Best Time to Put Oil in Car

Download Article

Download Article

The oil that runs through your vehicle's engine helps cool down all of its moving parts.^[1] You can save yourself a couple of bucks by changing the oil in your car yourself. While all vehicles are a little different, adding oil is something anyone can do with a little eye for detail and a willingness to get dirty. Adding oil, however, is not a substitute for getting your oil changed.

1. 1

   Check the oil after the car has rested for 5 minutes. If you check the oil right after turning the car off you will get an inaccurate reading, as some of the oil will still be at the top of the engine. Keep the car on a level, even surface as well to make sure you aren't checking the oil on a slant.^[2]

   • Most auto manufacturers require you check the oil after the car has been warmed by starting it in place for 3-5 minutes. Check your owner's manual if there is any doubt.^[3]
   • To be safe, you should check your oil every month, and more frequently if you have to drive long distances.

2. 

   2

   Pop the hood of the car. Usually you need to pull a small lever or press a button near the driver's seat to unlock the hood. From there, run your hand between the hood and the body of the car until you find a small lever, usually in the middle of the hood, and press it inward to completely free the hood.

   Advertisement

3. 

   3

   Locate the car's dipstick. This small, usually yellow cap with a loop is often labeled "Engine Oil," but even if it is not it is not difficult to find. The dipstick is a long piece of metal that extends down a tube to the oil pan, telling you, based on how high the oil line is, how much oil is in the engine. It is nearly close to the front of the car, and has a brightly colored circular or hook-shaped handle that you can use to pull out the stick without touching any oil.^[4]

4. 

   4

   Pull out the dipstick and wipe it down with a dry cloth. Oil from the engine will spurt up on the dipstick when the car is running, meaning you should clean it and reinsert it to get an accurate reading. Note the marks near the middle or bottom of the stick, often dots, lines, cross-hatched squares, or bends in the stick. The highest mark is the "Full Line," and your oil should be somewhere between the two lines.^[5]

5. 

   5

   Reinsert the dipstick and pull it out to check your oil. This time you should note where the oil is on the stick. It should be closer to the top mark than the bottom, usually as close as you can get it. However, unless the level is at or below the minimum mark you do not need to add more oil.^[6]

   • If the line is close and you are unsure whether or not to add oil, drive the car and check the oil again after 2-3 weeks.

6. 6

   Understand the appearance of the dipstick. Is the oil black, brown, or clear? Is the dipstick itself clean, or mottled and dark? Oil may start out light tan, but it will always darken with use as the engine runs, collecting impurities from the combustion cycle and from getting hot. Its color is also dependent on mileage. For example, if you are driving an older car 5000 miles a month, your car might burn a quart of oil a month.

   • If the oil looks milky or white you could have a coolant leak and must get the car towed to a mechanic immediately.
   • If the oil has metallic particles or bits in it, get it to a mechanic immediately.^[7]
   • If the oil seems dirty or sludge-like, it's time to change your oil.^[8]
   • You should not be filling up the oil every few weeks or month -- this could be the sign of a leak.^[9]

   Advertisement

1. 1

   Use the oil recommended in the owner's manual. There are not too many reasons to switch from the recommended oil in the owner's manual, but that oftentimes doesn't make buying oil any easier. Understanding the different numbers and ratings on motor oil packaging will make you a better consumer and can help keep your car running smoothly.^[10]

2. 2

   Understand how to read oil viscosity. Viscosity represents a fluids thickness, or resistance to flowing. A high viscosity is less likely to flow smoothly because it is thicker (yogurt is more viscous than milk, for example). There are two numbers for viscosity of an oil, represented in combination, like 10W-30 or 20W-50. The first number, with the W, is for the winter temperature of the oil. This tells you how well it flows in cold weather when it the oil is thicker. The second number is how well the oil maintains its thickness in heat.

   • The first number should be at least 5W or lower if you live in very cold areas (see your owner's manual), as oil can get too thick for the car to start if the winter viscosity is too high.
   • Your owner's manual will have a recommended viscosity rating for your car. If there is only one number, as found in some older cars, your car uses a "single-weight" oil.^[11]

3. 3

   Check your owner's manual for the necessary certifications your oil needs. This will help make sure your car stays healthy and under warranty. Each motor oil has several different certifications possible, from the starburst-shaped API to ILSAC recommended guidelines. Make sure whatever oil you use meets the standards put forth by your manufacturer.

   • Some certifications change as the get more modern. The current API designation is SL, though it has been SJ and SI before. Again, refer to your manual for your car.

4. 4

   Use synthetic oils for high-end cars or extreme conditions. Though more effective, synthetic oils are also more expensive than their natural counterparts.

   • Blending oils, however, is perfectly acceptable, so you do not have to shell out for pure synthetic oil if it seems too expensive.^[12]

5. 5

   Do not switch to a multi-weight oil on older cars. If your car has been running fine on a single weight oil (one viscosity rating), you don't want to switch now. This could cause sludge and grime that built up in the engine to dislodge and cause problems. Stick with what the car is used to and needs -- switching to a high-performance oil later will only cause more problems.

   • Consider switching in a higher weight oil (40 for 30) for the summer months, when it gets hotter, instead of switching to a multi-weight oil like 20W-40W.^[13]

   Advertisement

1. 1

   Add oil to the car if the dipstick reading is near the minimum line. You should top up your car immediately if you are at or below the proper oil level to prevent damage to your car. Adding oil to your car, however, is not a substitute for replacing your oil on a regular basis.

   • Always check your owner's manual to see how often you need to get your oil changed -- it may be as soon as 3,000 miles or as infrequently as every 20,000 miles. Most experts recommend changing oil every 5,000 miles.^[14]

2. 2

   Purchase the right oil for your car. Check your owner's manual to see what oil is right for your car, or talk to your mechanic. Do not switch away from the recommended oil unless you have a very good reason -- it will not necessarily make your car perform better unless it is made for that oil.

3. 3

   Pop the hood of the car. You need to pull a lever or press a button by the driver's seat to get the hood up. Return to the front of the car and run your hand between the hood and the body until you find a lever, usually in the middle of the hood. Press it inward to completely free the hood and expose the engine.

4. 

   4

   Find the oil fill port. It is almost always labeled oil with a small picture of an oil can on the top. If you have trouble, check the owner's manual, though it is usually found near the front of the car near the engine and the dipstick. Unscrew the top and set it aside.

5. 

   5

   Check the dipstick to determine how much oil you need to add. Usually, the difference between the bottom of the stick and the top is 1 quart,^[15] so you can use this to estimate how much oil you want to add. If it is halfway full, for example, you need to add half a quart of oil. That said, you should always add the oil in quarter quart increments to prevent overfilling, as this can cause serious engine issues.

6. 

   6

   Add oil slowly to the reservoir, checking periodically. Add oil for 2-3 seconds, wait a minute, and then check the dipstick. Clean it off when done, add some more oil, and check again. You want the oil level to be close to the top mark on the dipstick, so get it as close as you can without overflowing.

   • A funnel will make it easier to add oil without spilling it on the engine.

7. 

   7

   Close up the oil fill cap. You should rarely need to add more than a quart of oil. If you do, there may be more serious issues at play in the engine, and you should check the oil again within a week to check if it's leaking. Otherwise, your engine should be good to run. Remember to get your oil changed when it is dirty or after 5,000 miles.^[16]

   Advertisement

Add New Question

• Question

  When should I add oil to my car?

  

  Tom Eisenberg is the Owner and General Manager of West Coast Tires & Service in Los Angeles, California, a family-owned AAA-approved and certified auto shop. Tom has over 10 years of experience in the auto industry. Modern Tire Dealer Magazine voted his shop one of the Best 10 Operations in the Country.

  

  Auto Technician

  Expert Answer

  

  Support wikiHow by unlocking this expert answer.

  How often you should completely change your car's oil depends on the type of oil your vehicle takes. Conventional oil usually lasts between 3,500 and 5,000 miles. Higher-grade synthetic oil typically lasts between 7,500 and 10,000 miles.

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertisement

Video

Things You'll Need

• Oil
• Funnel
• Napkin, rag, tissue or towel (to wipe dipstick)

• Perform an internet search for your car's make, model, and year if you don't know what type of oil you should add.

Advertisement

• Keep any open flames away from the engine as you work.

• Be cautious when working on the car while the engine is hot.

Advertisement

About This Article

Article SummaryX

If you need to add oil to your car, pop the hood of your car and find the oil fill port, which is almost always labeled "Oil" with a small picture of an oil can on the top. Unscrew the cap, then check the dipstick to determine how much oil you need to add. Usually, the distance between the bottom of the stick and the top is equal to 1 quart of oil, so estimate based on that. Add the oil to the reservoir slowly, checking the dipstick periodically, then close the oil fill cap. Keep reading for tips from our mechanic reviewer on how to choose the right oil for your car!

Did this summary help you?

Thanks to all authors for creating a page that has been read 596,008 times.

Did this article help you?

When Is Best Time to Put Oil in Car

Source: https://www.wikihow.com/Add-Oil-to-Your-Car

Share this post